Go Back
–+ servings
Urad dal vada recipe (Ulundu vadai with pepper)
Print Recipe
No ratings yet

Urad Dal Vada Recipe (Ulundu Vadai With Pepper)

Crispy and fluffy South Indian urad dal vada recipe (pepper medhu vadai) made by grinding batter in a mixie. Learn the exact water ratio, batter consistency test and 3 easy shaping methods for golden, oil-free vadai.
Prep Time1 hour
Cook Time20 minutes
Total Time1 hour 20 minutes
Course: Festival recipes, Snack
Cuisine: South Indian, Tamil nadu
Servings: 8 vadas
Author: Chitra

Ingredients

Main Ingredients

  • 1 cup White round urad dal (gota urad) approx. 200 g / 7 oz
  • ¼ cup Ice water (plus 2 tbsp extra to grind) approx. 60-90 ml
  • Salt as needed
  • ¼ tsp Asafetida / hing
  • 1 tbsp Crushed black peppercorns
  • 1 tsp Rice flour optional, adjust as needed
  • Few Curry leaves finely chopped
  • Oil to deep fry

Instructions

  • Wash and soak the urad dal for 1 hour inside the refrigerator. Drain all the water completely and use chilled ice water for grinding the batter. Chilled water helps to prevent the mixie jar from heating up while grinding.
    Soaking urad dal in refrigerator for medhu vadai batter
  • Take the soaked dal in a medium or bigger size mixie jar as the batter increases in volume while grinding. Add 1/4 cup of ice water and the required salt.
    Adding soaked urad dal and ice water to mixie jar
  • Grind for some time until the batter turns slightly coarse. Stop the mixie, wipe the sides and lid. Add a tablespoon of ice water and run the mixie for one more minute. Batter should be fluffy, white and completely smooth. Add more water spoon by spoon till it becomes a smooth paste.
    Grinding urad dal batter in mixie until thick and smooth
  • Take a small bowl of water and put a drop of batter into it. If the batter floats on top and does not dissolve or settle down, the consistency is correct. Add one more tablespoon of water if necessary. Transfer the batter to a bowl, add hing, crushed peppercorns, curry leaves and rice flour (if using). Mix well in one direction.
    Checking batter consistency in water and mixing hing, pepper and curry leaves
  • Heat oil in a kadai. When a drop of batter rises immediately, the oil temperature is right. Keep a bowl of water nearby to keep hands wet. Method 1: Take a small ball of batter and place it on a greased milk cover or polythene sheet. Pat it slightly thick, make a hole in the center, and gently drop into hot oil.
    Method 1 - Patting batter and making hole in the center
  • Method 2: Grease your left hand with a little oil and water. Place a ball of batter, pat and make a hole in the center. Transfer to your right hand fingers and slide gently into hot oil.
    Method 2 - Making center hole on hand and transferring to fingers
  • Method 3: Take a small ball of batter on your right hand fingers. Make a hole in the center using your thumb finger. Invert your hand over the oil and drop the vadai by slightly tilting your fingers.
    Method 3 - Shaping vadai directly on fingers with thumb hole
  • Deep fry the vadai on both sides on medium flame until golden brown and crispy. Drain on paper towels and serve hot with chutney or sambar!
    Frying urad dal vada until golden brown and crispy on both sides

Video

Notes

  • If you grind the batter in a grinder, add the dal little by little while the grinder is running. Add 1/4 cup of water and stand nearby. After a few minutes, the batter will rise and turn fluffy. Now wipe the sides and sprinkle a little more water (around 2 tbsp). Grind for some more time. The batter will be very smooth, fluffy and white. This takes 15-20 minutes based on the grinder, and the batter quantity increases significantly. Remove and proceed as mentioned above.
  • If you do not add salt while grinding the dal, you may have to add a little more water (around 2 tbsp).
  • If your batter is slightly watery, add a teaspoon of rice flour, mix well and make vada. If you eat immediately, you can add more than a teaspoon of rice flour too. You will get crispier vada, but when it cools down, it will become hard.
  • You can also try refrigerating the batter for some time if it is slightly thin.
  • Vada absorbs oil if the water in the batter is too much. If so, next time add slightly less water.
  • Do not deep fry the vada on low flame. This makes the vada absorb more oil. Adjust the flame from medium-high to medium whenever necessary.
  • My mother-in-law soaks a teaspoon of toor dal along with urad dal to avoid oil absorption. In hotels, they add 2 teaspoons of raw rice while soaking urad dal.
  • For making vada with onions: first grind 2-3 green chillies and a small piece of ginger along with urad dal. Grind the batter, then mix in finely chopped small onions, a teaspoon of hing and finely chopped curry leaves. Follow the same frying procedure. Add less water while grinding for onion vada because onions release moisture.
  • The water to urad dal ratio is 1:4. It may need 2 to 3 tablespoons of extra water. Please do not add more than that.
  • Every time dip your hands in water generously before shaping so that the vada slides into the oil easily without sticking to your hands.
  • If the center hole becomes small after dropping the vada into the oil, you can gently reshape the hole using the back of a chapati rolling pin or wooden spoon handle dipped in oil.
  • If grinding in a mixie, always prepare the vada just before serving and eat hot for the best taste and crispness.
  • Serve hot with your favorite coconut chutney or tiffin sambar.
  • For sambar vada or curd vada, dip the hot vadai in a bowl of warm water for a few seconds, gently squeeze between your palms to remove excess water, and immediately soak in warm sambar or beaten seasoned curd (thayir).